Publicité
Les langues disponibles
Les langues disponibles
5.
Install the plinth and the rear base support below the firebox
(optional).
The purpose of the plinth is to allow the appliance to be placed
on a rough subfloor, such as plywood, without regard for the
additional thickness of floor finishes as the appliance bottom
must otherwise be placed at the finished hearth height or the
front trims will not fit properly on the appliance.
a)
Detach the burner module from the appliance by removing
its 11 screws.
b)
Fit the rear base support under the rear of the appliance
attaching it to the appliance back panel with 2 x ⅜" thread
cutting (pointed end) screws.
c)
Fit the front plinth under the appliance front with 2 thread
forming screws.
6.
Install the top insulation layer. For top vent outlet appliances,
cut out a circle at the center of the insulation layer for the vent
collar. Place the insulation layer on top of the appliance case
inboard of the stand-off spacers.
! Warning: Failure to install the insulation layer may cause
a fire hazard and void warranty.
7.
If the hooks have been shipped loose with the cast front,
fix them to the front at its top corners. Hang the front on the
appliance.
Pull forward to expose
width of 4"
Cut out insulation
for top vent installation
4"
(102 mm)
total
insulation
7
Publicité
