Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
1.
Fit the top baffle under the top panel of the appliance
case. Secure with 2 thread forming screws.
2.
Fit the stand-off spacers. The stand-off spacers for
these installations are supplied flat. They are left and
right handed.
! Warning: Failure to install the stand-off spacers
may result in a fire hazard.
a)
Remove the 2 screws near each of the rear top
corners of the appliance and the 2 screws near
each side of the top back corners.
b)
Bend the spacers as shown.
c)
Screw the spacers to the rear of the appliance
using the screws just removed.
d)
Bend the side wings of the spacers to align the 2
holes in each spacer with those in the appliance
sides. Secure the spacers using the screws just
removed.
3.
Mount the framing plate to the appliance.
4.
Secure the framing plate and brackets to the sides
of the appliance case with 4 thread cutting screws
supplied. Screw from the outside through the access
holes in the framing plate.
Note: There are alternate methods of finishing around
the framing plate—either leaving it exposed or
recessing it and covering it up with the wall finish. See
page 4.
6
Publicité
