Saci E-motion Manuel D'installation Et D'entretien page 29

NOTE: The indications on the part number refer to the spare parts components on page 112.
c) Installation on motor:
- Replace the cover of the motor terminal box by the motor support adapter (parts 5 and 11a).
- Drill with a screwdriver, carefully and with a thud, the 3 holes in the metal radiator power circuit (part 4). The 3
holes are marked on the inside of the radiator.
- Screw the metal radiator to the motor support adapter with the help of the 2 screws provided for this purpose
(parts 9 and 11b).
- Make the electrical connections between circuit and electric motor using the supplied cable (part 6).
- Connect the flat cable through the power circuit to the cover + control circuit (part 1).
- Screw the set (part 13).
d) Installation on wall bracket:
WARNING: For installation on wall bracket must not be performed paragraph 2 above, concerning the installation
on motor, because if the 3 holes exists in the metal radiator, the drive lose it's tightness.
- Fix the wall bracket to the wall through holes 3 rear wall bracket (part 7).
- Place the fan at the base of the wall bracket securing the position of airflow up (part 8).
- Position the drive assembly in the wall bracket, ensuring that the 2 ends of the metal radiator remain inside the
wall bracket.
- Set the inverter to the wall bracket through the 2 side screws drilled into the metal radiator (part 14).
27
ENGLISH