Start/Stop/Reverse Function; Locking The Hand Control Setting; Possible Values For Each Parameter; Session Time - Kinetec Spectra Manuel D'utilisation

START / STOP / REVERSE function
As with all Kinetec
®
functions.
Press the key of the hand control. The movement stops,
Press the key of the hand control. The movement starts in the opposite direction.
For optimum safety, always give the hand control to the patient before starting the system.
Procedure to stop the machine:
To stop the machine's movement: press the [stop] button,
To switch power off: press the ON / OFF switch (9) (see page 6)

Locking the hand control setting

The hand control allows the patient to control the machine as appropriate.
Simultaneously press the
The display reads "LOCK", you cannot change the parameters; if you try the message
LOCK will be displayed. The Start and Stop keys are still active.
To unlock the hand control, simultaneously press the same keys. The display will show UNLOCK.
We recommend that you lock the hand control when you give it to the patient.
Note: the hand control locking is preserved when you switch the unit ON/OFF.

Possible values for each parameter

• Treatment mode
• Extension limit
• Flexion limit
• Speed
• Force
• Extension Pause
• Flexion pause
• Timer
• Number of Programs

Session Time

This function shows the running time (in minutes) of the session (motor functioning).
It is directly accessible by the key
This counter is reset each time the unit is switched ON.
Kinetec Spectra™
systems, the devices Kinetec Spectra™ are equipped with ON/OFF/REVERSE
and
, the display shows TIME
CAUTION
keys to lock the hand control.
Possible values
-10 to 115°
-5° to 120°
1 to 5 (from 45° to 155° per
minute)
1 to 6
0 to 900 seconds (15 minutes)
0 to 900 seconds (15 minutes)
No timer (00H00) to 24H00
16
EN
Default setting
Normal
30°
70°
2
6
0
0
0
Empty
02H35
7/20