Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11.3.
START / STOP / REVERSE function
As with all KINETEC
function.
Press the
Press the
For optimum safety, always give the hand control to the patient before starting the system.
11.4.
Procedure to stop the machine:
To stop the machine's movement: press the
To switch the unit off: press the ON / OFF switch (11) (see page 6)
11.5.
Locking-Unlocking the hand control setting
The hand control allows the patient to control the machine as appropriate.
Simultaneously press the
The display reads "LOCK", you cannot change the parameters; if you try, the message "LOCK"
will be displayed.
To unlock the hand control, simultaneously press the
"UNLOCK".
We recommend that you lock the hand control when you give it to the patient.
Note: hand control locking is preserved when you switch the unit ON/OFF.
11.6.
Possible values for each parameter
Flexion/Dorsiflexion
Plantar Flexion 40°
• Lower limit
Dorsiflexion 25°
Plantar Flexion 35°
• Upper limit
Dorsiflexion 30°
• Speed
• Force
• Extension pause
• Flexion pause
• Timer
Kinetec Breva™
systems, the device Kinetec Breva™ is equipped with a START/STOP/REVERSE
®
key of the hand control. The movement stops,
key of the hand control. The movement starts in the opposite direction.
and
Possible values
Plantar
Inversion/Eversion
25° 'inversion to
20° eversion, right foot
25° eversion to
20° inversion, left foot
20° 'inversion to
25° eversion, right foot
20° eversion to
25° inversion, left foot
1 to 5 (from 50 to 150° per minute)
1 to 6
0 to 900 seconds (15 minutes)
0 to 900 seconds (15 minutes)
No timer (00H00) to 24H00
CAUTION
key
keys to lock the hand control.
and
Plantar Flexion/Dorsiflexion
Plantar flexion 20°
Dorsiflexion 0°
EN
keys, the display reads
Default setting
Inversion/Eversion
10° Inversion or Eversion,
depending on the foot
10° Eversion or Inversion,
depending on the foot
2
6
0
0
0
7/20
Publicité
Chapitres
Table des Matières
Dépannage
