Modification De L'aération Du Haut Vers L'arrière - Lopi NorthField GS2 Manuel Du Propriétaire

12
Modification de l'aération du haut vers l'arrière
REMARQUE: Si vous utilisez la configuration de l'évent arrière, assurez-
vous d'examiner la configuration de l'évent avant de continuer.
Retirez le dessus de la cuisinière en fonte et le couvercle de la cheminée pour accéder aux composants de la ventilation
(voir page Error! Bookmark not defined.)
Remove the outer flue
assembly, cover plate, and
gaskets. Place the screws
and components aside (for
all subsequent steps).
Remove the inner flue
assembly and exhaust cover
plate.
ADJUSTING THE DIFFUSER ON THE INNER FLUE ASSEMBLY
Rear vent configurations with no rise require the
diffuser to be bent to the # 2 position. It is easiest
to adjust this component with the inner flue
removed. See the directions below.
Bottom of inner
flue assembly
© Travis Industries
Installation
a
Remove the
diffuser.
(for qualified installers only)
NOTE: Use a magnetic-tipped
nutdriver on these screws - take
care to prevent the screws from
falling into the intake channel.
Inner Flue
Assembly
Exhaust Cover Plate
b
Bend the round portion of the
diffuser so it is bent (position # 2).
DIFFUSER SIDE VIEW
Before (Stock - Position # 1)
After (Position # 2)
4140814
c
Replace the
diffuser.
100-01400