Prebena AEROTAINER 240 Mode D'emploi page 70

Maintenance of compressor
Drain of condensate moisture from the dehumidifier
PREMO 400
Condensing moisture (condensate) is collected in a transparent container of dehumidifier. The volume of
condensate depends on the load compressor and on the temperature of environment around compressor.
Drain condensate after each use:
Condensate can be drained in semi-automatic and manual mode.
ATTANTION!
Condensate is a harmful substance. It represents a threat to the environment.
Place a suitable container under the drain hole.
To immobilize spilled condensate using a binder.
To collect immobilized condensate with a rag.
To utilize the rag in accordance with applicable legal requirements of the application site.
WARNING!
Damage of compressor or its components due to the use of unsuitable cleanser.
For cleaning use only dry, slightly dampened duster or the duster soaked in a mild soap solution.
Light contamination
Clean the compressor casing with a dry duster.
Lubricate all metal parts of the compressor with a thin layer of special oil Prebena.
Strong contamination
32
Condensate is automatically discharged from a transparent container (2) when
the container is not under pressure. With increasing the pressure above 1 bar
the valve of drain hole for condensate drain (1) is closed again.
To drain the condensate in manual mode, proceed as follows:
Open by pressing the valve of drain hole for condensate drain (1). Con-
densate is discharged under pressure from a transparent container (2).
After a successful drain close the valve of drain hole for condensate drain
(1).
Cleaning the casing and external surfaces
Connect the air gun to the compressor (1) and clean all ribbed
parts with compressed air.
Clean the compressor casing using a duster slightly dampened
in a mild soap solution.
Finally wipe the casing using a duster slightly dampened in tap
water.
Completely wipe with a dry, soft duster.
Lubricate all metal parts of the compressor with a thin layer of
special oil Prebena.