Publicité
Les langues disponibles
Les langues disponibles
Transportation and storage of compressor
Transportation and storage of compressor
Packaging
Before shipment for storage or before transportation for a long-distance, pack compressor in the original packaging, es-
pecially when moving at a distance:
More that 10 m
over uneven surfaces.
To do this, perform the following preparatory actions:
Follow the actions described on page 28 "After operation".
Clean the connections for compressed air supply from foreign bodies and dirt.
Pack compressor in the original packaging.
Transportation
Type of transportation varies depending on the compressor moves for short or long distances.
Transportation for short distances
Short distances it is maximum 10 m
Follow the actions described on page 28 "After operation".
ATTENTION!
Shocks or strikes can damage the compressor.
Avoid dropping the compressor.
Avoid striking the compressor on the obstacles.
If it is a transferable compressor: when moving, then hold the compressor for the handle, so it does not tip over.
VIGON 120
AEROTAINER 240
WORKLINE 100
Move the compressor taking it at the handle to a
new place of work.
Connect the edge device to the compressor only at
the new place of work.
Transportation for long distances
The following distances are long for the compressor transportation:
distances more than 10 m,
distances over uneven surfaces and
moving in unusual position
Transportation of compressor over long distances is allowed only in the original box.
For transportation of compressor over long distances, proceed as follows:
Follow the actions described on page 29 "After operation".
Pack the compressor in the original box in which it was delivered.
Move to the necessary place of work in its original packaging, holding the two holes for lifting.
Place the original box just straight the lid up.
Storage
Lubricate all metal parts of the compressor with a thin layer of special oil Prebena.
Pack the compressor in the original box.
Store the compressor at room temperature in a dry and dust-free place.
28
VIGON 240
VIGON 300
NEER 282
PIONEER 342
STAR 450
TWINSTAR 690
Move the compressor taking it at the handle to a new
place of work.
Connect the edge device to the compressor only at the
new place of work.
PREMO 400 PIO-
ORKAN 215 TWIN-
Publicité
