Aux Mode; Usb Mode - Krüger & Matz EXPLORER KM0552 Mode D'emploi

* If the device will not enter Bluetooth mode automatically after power on or if you
want to switch to Bluetooth mode, press the BT button to manually enter pairing
mode.
Press and hold the BT button for about 2 seconds to disconnect with current external
device and reenter pairing mode.
Notes:
• Every time the speaker is switched on, it will connect to last connected device
automatically. Please note, your device must be on with Bluetooth function
turned on.
• The device will turn off automatically after about 10 minutes of no operation.

AUX MODE

1. Use the 3,5 mm jack cable and connect one plug of the cable to the speaker's
AUX input.
2. Connect the other plug into the 3,5 mm output of the external device you wish
to play music from.
3. The device should automatically enter AUX mode. If jack cable has been
connected to the speaker before power on, press the power button to enter AUX
mode (backlight of the power button should change from blue to white).
4. Start playing music from your device.
5. During music playback, white backlight of the power button blinks. When music
is paused, white backlight is on.
6. Control music playback and volume from the speaker. Use connected external
device to select desired track.

USB MODE

1. Connect the USB drive to the USB input of the speaker.
2. The device should automatically enter USB mode. If USB drive has been
connected to the speaker before power on, press the power button to enter USB
mode (backlight of the power button should change from blue to white).
3. Start playing music from your device.
4. During music playback, white backlight of the power button blinks. When music
is paused, white backlight is on.
5. Control music playback, volume and track selection from the speaker.
14
Owner's manual