Krüger & Matz EXPLORER KM0552 Mode D'emploi page 15

Owner's manual
MICROSD CARD MODE
1. Insert the microSD card into the appropriate slot of the speaker.
2. The device should automatically enter microSD mode. If microSD card has been
inserted into the slot before power on, press the power button to enter microSD
card mode (backlight of the power button should change from blue to white).
3. Start playing music from your device.
4. During music playback, white backlight of the power button blinks. When music
is paused, white backlight is on.
5. Control music playback, volume and track selection from the speaker.
CHARGING
1. Connect USB Type-C plug of the included charging cable to the USB Type-C
socket of the speaker.
2. Connect the other plug to the compatible PC USB port or AC charger.
3. When the battery is charging, charging indicators are blinking.
4. When the battery is fully charged, all charging indicators are on.
5. Disconnect the charging cable from the speaker and power source.
CHARGING EXTERNAL DEVICE
1. Make sure the speaker is turned on.
2. Connect the external device with the USB cable (not included in the set) to the
USB output of the speaker.
3. Charging should start automatically.
TWS MODE
You can connect only the speakers of the same model.
You can connect speakers only when in Bluetooth mode.
1. Make sure the speaker A is already connected with the external device.
2. Turn on the speaker B.
3. Press and hold the TWS button of the speaker A for about 3 to 5 seconds. White
backlight of the TWS button blinks.
4. After successful connection between the speakers, white backlight of the TWS
button is on.
5. Now both speakers should simultaneously play music.
6. You can disconnect the speakers by pressing and holding the TWS button on
either speaker for about 3 seconds.
7. Manage all functions using buttons on either speaker.
15