Replacing Filters - shark IC160 Série Mode D'emploi

MAINTENANCE
Your vacuum comes equipped with three filters located on the vacuum pod: two pre-motor filters and
one HEPA filter to capture and trap dust and debris.
CLEANING PRE-MOTOR FILTER (ONCE A MONTH)
Perform maintenance on your filters once a month to keep your vacuum's suction power optimal.
IMPORTANT: Rinse pre-motor filter and frame with water ONLY. DO NOT use soap. Allow to completely
air-dry for at least 24 hours before reinstalling.
Filter
Filter
Frame
s h a r kc l e a n . c o m
Filter
Door
1. Slide down Filter Door release button.
2. Tilt filter door and lift off.
3. Remove filter from pod. Pull filter off frame.
4. Rinse filter and filter frame with water ONLY.
5. Once completely dry, reinsert filter onto
filter frame.
6. While holding the tabs on the frame, slide the
filter back completely to secure into place.
7. Reinsert bottom of filter door into slots on pod.
Tilt door to close, pressing until it clicks into place.
MAINTENANCE
CLEANING HEPA FILTER (ONCE A YEAR)
Perform maintenance on your HEPA filter once a year to keep your vacuum's suction power optimal.
IMPORTANT: Rinse HEPA filter with water ONLY. DO NOT use soap. Allow to completely air-dry for at
least 24 hours before reinstalling. DO NOT scrub HEPA filter.
HEPA
Filter

REPLACING FILTERS

Follow the previous instructions for removing filters. The Pre-Motor Filter should be replaced every
2.5 years. The HEPA Filter should be replaced every 3 years.
Replacement Pre-Motor
Foam & Felt Filter Kit
XFFK160
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
1. Pull up on HEPA Filter access tab to remove.
2. Rinse filter with water ONLY and let air-dry for
24 hours before reinstalling.
3. When dry, reinsert HEPA Filter and press down
until it clicks into place.
Replacement HEPA Filter
XHEPA160
s h a r kc l e a n . c o m