Emptying The Dust Cup; Important; Replacing Filters - shark Navigator Zero-M Pet Pro ZU60 Série Guide D'utilisation

EMPTYING THE DUST CUP

IMPORTANT: Unplug the power cord before performing any maintenance.
To remove Dust Cup, press button on top of dust
cup handle. Tilt dust cup forward, then lift to
remove.
To remove collected debris from Lint Screen,
press top release button and lift handle to
open. Gently brush lint screen to clean.
sharkc le a n.com
Press lower release button to open bottom of
dust cup.
To reinstall, place bottom of dust cup into
pod and then tilt back until it clicks into place.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
Regularly clean and replace your filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water only to prevent damage from cleaning chemicals. Allow all
filters to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn
into electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
Foam
Felt
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove Dust Cup, then lift out Filters.

REPLACING FILTERS

Follow the previous instructions for removing filters. The Pre-Motor Filter should be replaced every
2.5 years. The HEPA Filter should be replaced every 3 years.
Replacement
Pre-Motor Foam &
Felt Filter Kit
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
Post-Motor
Filter
Cover
latch
CLEAN HEPA FILTER
EVERY YEAR
Press down top of Filter Door. Tilt Filter Door
and lift out. Press tab at top of HEPA Filter
and pull away from the base of the vacuum.
To reinstall, insert HEPA filter into unit and
replace the filter door.
Replacement
HEPA Filter
s ha r kc lea n.com