shark IC160 Série Mode D'emploi page 7

MAINTENANCE
CLEANING OR REPLACING BRUSHROLLS
BRUSHROLL
TURN LOCKS LIFT COVER
1. Using a coin, turn locks counterclockwise to
open, then lift off cover to access Brushroll.
2. Use scissors to cut along the groove in the
brushroll to remove any string, hair, or debris.
3. Check for blockages in Debris Intake.
4. Replace cover and turn locks clockwise to close.
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
s h a r kc l e a n . c o m
SOFT ROLLER
1. Slide Eject Roller button.
2. To remove Soft Roller, pull out the right end first.
3. Tap loose debris off the Soft Roller. Use a dry
towel to wipe clean, or to remove any hair or
fibers caught in the teeth behind the Soft Roller.
4. Rinse as needed. Use ONLY water, and let air-dry
completely for at least 24 hours.
5.
When dry, insert the left end of the roller first,
then push the right end into place with the
word Front facing forward.
MAINTENANCE
CHECKING FOR BLOCKAGES
IMPORTANT: DO NOT use sharp or metal objects to clear blockages.
Detach hose from vacuum pod, and check
opening on back of pod for blockages.
Detach handle from wand and hose from the
vacuum pod, and check openings for blockages.
Detach wand from floor nozzle. Tilt nozzle
neck back to straighten the airway, and
remove any blockages.
NOTE: Turn off vacuum and remove battery before checking for blockages.
Detach dust cup from vacuum pod. Empty dust
cup, remove debris from lint screen, and check
for blockages.
Detach wand from floor nozzle and handle,
and check both ends of wand for blockages.
s h a r kc l e a n . c o m