SFA SANICOMPACT Instructions D'installation Et D'entretien page 5

7340 NOTICE N°204 4/02/08
USAGE
5h
After use, activate the push button (air switch) located on
the rear left side of the bowl. Other than regular cleaning,
the SANICOMPACT does not need any maintenance. The
®
stops the macerating cycle automatically
SANICOMPACT ®
after activating the switch.
The SANICOMPACT is to be used only for human waste
®
and toilet paper. Foreign material such as sanitary napkins,
tampons, condoms, cotton buds, cotton strands of mops,
cat litter, etc. will damage the macerating/pump unit and
will void the warranty.
It is strongly recommended to use only toilet paper , e.g.,
single sheet paper. Do not flush newspaper, printing
material, paper towels and other non-absorbent material, ect .
Avoid solvents, oils, paints, food particles, plastic bags etc.
because chemicals and foreign materials may seriously
damage the pump unit.
To clean & descale the toilet bowl, use an adequate descaler
that does not contain bleach or chlorine base.
The frequency of descaling depends on the water quality in
your region. We recommend that it is done at least twice a year .
In case of electrical power failure of any duration, it is
necessary to close the Shut-Off valve, because leaks,
no matter how small, may fill up the bowl in time and
cause flooding.
Note: While dressing, do not sit on the lid of the
. It will shatter.
SANICOMPACT ®
RETURN OF THE UNIT
5i
In the unfortunate event that the SANICOMPACT
defective and has to be returned for service, we suggest to
remove the macerating/pump from the porcelain bowl.
Please ensure that it has been thoroughly cleaned and
disinfected inside and outside prior to packaging for dispatch.
Do not submerge the motor completely in water; the
electrical components might be damaged beyond repair .
DISMANTLING AND REMOVING THE MOTOR FROM
5j
THE TOILET
FOR QUALIFIED PERSONNEL ONLY
1. Disconnect the SANICOMPACT
2. Close the Shut-Off valve and disconnect toilet supply
tube.
3. (If installed) Close Gate or Ball Valve and disconnect
from discharge pipe system.
4. Remove rear screws holding the SANICOMPACT
the floor.
5. Remove front screws that holds the motor unit to the
china.
6. In the rear of the unit, look for a clear plastic hose going
from the solenoid valve to a black elbow in the top of the
bowl. With a twisting motion pull the black elbow out of
the porcelain.
7. In the rear of the unit, look for a large rubber elbow ,
going from the motor to the p-trap of the toilet. Unscrew
the gear clamp near the motor (holding the rubber
elbow).
8. The motor is assembled in the reverse of the above.
9:19 Page 5
is
®
from the electrical supply.
®
to
®
IMPORTANT / SERVICE
Before returning the motor to the factory, a return
authorization is needed from the manufacturer since some
repairs may be done in the field. Parts or motors send in for
repair, must be send pre-paid. Units send collect and/or
send without prior authorization, will be refused.
Package the macerating/pump unit properly with adequate
shock absorbent material around it. Send package prepaid
to the manufacturer, making sure to insure against loss
and/or transit damage, (the amount of $ 250.00 will
suffice).
If any repairs are done outside the warranty period, or when
the user damages the macerating/pump unit, an estimate of
repair cost will be mailed to the customer . All repairs (parts
and labour) will be done on a pre-paid basis only.