Canopy Assembly; Blade Assembly - Craftmade Optimum Guide D'installation

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed and then tighten both screws securely.
Slide canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with screwheads
in bottom of canopy. Turn canopy cover to the right
(clockwise) until it stops.

8. Blade Assembly.

WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and break.
Locate 15 blade attachment screws/washers
in hardware pack. Hold blade arm up to blade
and align holes. Insert 3 blade attachment
screws/washers with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for the
remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor
locks are installed with blade arm screws,
discard plastic motor locks (save blade arm
screws and lock washers to secure blade arms).
Align blade arm holes with motor screw holes
and attach blade arm with lock washers and
blade arm screws. Before securing screws
permanently, repeat procedure with
remaining blade arms. Securely tighten all
screws.
Note: Tighten blade arm screws twice a year.
screw
canopy
plastic
motor
lock
lock washers
page 8
hanging bracket
screw
canopy cover
motor
housing
blade attachment
screws/washers
blade
blade arm
blade arm
screws