Canopy Assembly; Blade Assembly - Craftmade Waterfront WAT52 Instructions D'installation

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.

8. Blade Assembly.

WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If overtightened,
blades may crack and break.
Locate 16 blade attachment screws and
washers in hardware pack. Slide blade
through two of the narrow, square
openings on motor housing, aligning holes
in blade with holes in blade arm (located
on the underside of the motor
housing)--refer to drawing at right.
[IMPORTANT: Turn blade so label
indicating THIS SIDE UP faces motor
housing.] Insert 4 blade attachment
screws with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for each remaining
blade.
Note: Tighten blade attachment screws
twice a year.
canopy
screw
blade attachment
screws/washers
page 8
hanging bracket
screw
canopy cover
motor housing
blade
blade
arm