Canopy Assembly; Blade Assembly - Craftmade Pill PIL52 Guide D'installation

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the
open end of the hanging bracket. Partially
loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of
slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy
to lock. Re-insert screw that was removed and
then tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.

8. Blade Assembly.

WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades. If overtightened, blades may crack and
break.
Locate 3 blade plates and 9 blade attachment
screws/washers in hardware pack. Slide a blade
through one of the narrow, rectangular openings
on the center band, aligning holes in blade with
holes in blade arm located on the underside of
the center band --refer to drawing at right. Hold 1
blade plate up to a blade, placing the flat side of
the blade plate against the blade, and align holes
as shown. Insert 3 blade attachment
screws/washers with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for each
remaining blade.
Note: Tighten blade attachment screws twice a
year.
canopy
screw
blade plate
page 7
hanging
bracket
screw
canopy cover
motor housing
blade
blade
arm
blade attachment
screws/washers