Testing Your Fan - Craftmade Optimum Guide D'installation

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan
speeds with pull chain. (diagram 1) Start at the
OFF position (no blade movement). First pull
will set the fan to HI. Second pull will set the fan
to MEDIUM-HI. Third pull will set the fan to
MEDIUM-LOW. Fourth pull will set the fan to
LOW. Fifth pull will again set the fan to the OFF
setting. If fan does not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to recirculate
air depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the RIGHT
for fan to function. If the reverse switch is set in
the middle position (diagram 4), fan will not
operate.
Attach pull chain extension supplied or custom
pull chain extension (sold separately) to the end
of the pull chain.
reverse
switch
diagram 1
diagram 2
page 10
pull chain
extension
diagram 3 diagram 4
motor
housing