Important; Canopy Assembly - Craftmade Ellington Regatto Guide D'installation

6. Wiring. (cont.)
[PLEASE NOTE: Wall and/or handheld remote
control must be used for fan to operate. If you do
not wish to use the wall control, please proceed to
Section 7 to continue with fan installation.]
To install wall control, remove existing wall
switch. Wire one of the wall controls with wire
connectors provided as shown in diagram at right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Install one 12-volt battery (included) in wall
control.
IMPORTANT: Wall control will not function unless
battery is installed.
Since this fan comes with incandescent bulbs,
the dimmer switch (labeled DIM and ON) has
been pre-set to the "ON" position (DIM). If you do
not wish to have dimming capability, please
move the switch to the "OFF" position (ON).
Select a faceplate (almond or white) and press
firmly onto front of wall control. Attach wall
control to outlet box and secure with screws from
original wall switch. Attach wall plate (included) to
wall control using 2 screws provided with the wall
control.

7. Canopy Assembly.

Raise canopy to hanging bracket and align
slotted holes in canopy with loosened screws
in hanging bracket. Twist canopy to lock.
Re-insert screws that were previously
removed (page 3, Section 4) and secure all
screws with a Phillips screwdriver.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.
All manuals and user guides at all-guides.com
outlet box
page 6
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
wall control
green/ green/
green/
bare bare bare
ground ground ground
green
black (OUT to fan)
black
black
(TO POWER supply)
black
(AC IN from
breaker box)
12V battery
(wiring for wall control)
radio
radio or television
dimmer
switch
-
1 1
face-
DIM ON
plate
wall plate
hanging bracket
antenna
canopy