Canopy Assembly; Blade Assembly - Craftmade Beckham BEK54 Guide D'installation

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed, and then tighten both screws securely.
Slide canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with screw heads
in bottom of canopy. Turn canopy cover to the right
(clockwise) until it stops.

8. Blade Assembly.

WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If overtightened,
blades may crack and break.
Remove 9 blade attachment screw/washers
from the outer edge on the underside of the
motor housing. Align blade holes with
motor screw holes and attach blade with
screw/washers previously removed. Repeat
procedure for the remaining blades.
Securely tighten all screws with a Phillips
screwdriver.
Note: Tighten blade arm screws twice a year.
screw
page 8
hanging bracket
canopy
screw
canopy cover
motor housing
blade
blade attachment
screws/washers