Switch Housing Assembly - Craftmade Optimum Guide D'installation

9. Switch Housing Assembly.

Remove 3 screws from outer edge of fitter
plate (save screws for later use).
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws.
Align slotted holes in middle of fitter plate
with loosened screws in motor plate,
allowing male plug from motor housing to
come through hole in middle of fitter plate.
Twist fitter plate to lock. Re-insert screw that
was just removed and securely tighten all 3
screws.
Connect male plug from fan to female plug
from switch housing, matching up the colors
on the male plug with the colors on the
female plug for correct fit. Be sure that the
plugs connect completely.
Align holes in switch housing with holes in
fitter plate. Re-insert screws that were just
removed and securely tighten all 3 screws
with a Phillips screwdriver.
motor plate
screw
fitter plate
page 9
male plug
female plug
switch housing
motor
housing