Leuze electronic CSL 710 Mode D'emploi page 14

EN
CSL 710 with IO-Link interface
3
A Receiver (R)
B Transmitter (T)
C Connection cable (M12 socket, 8-pin)
D Synchronization cable (M12 plug/socket, 5-pin)
E PWR IN/OUT
Connect
Ä
Connect connection X2 to connection X3 using the appropriate synchroniza-
tion cable.
Ä
Connect connection X1 to the voltage supply and the control using the appro-
priate connection cable.
PIN X1 - Logic and power on the receiver
1 VIN: +24 V DC supply voltage
2 IO 1: input/output (configurable)
Factory settings: teach input (Teach In)
3 GND: ground (0 V)
4 C/Q: IO-Link communication
5 IO 2: input/output (configurable)
Factory settings: Trigger input (Trigger In)
6 IO 3: input/output (configurable)
7 IO 4: input/output (configurable)
8 GND: ground (0 V)
PIN X2/X3 - Transmitter and receiver
1 SHD: FE functional earth, shield
2 VIN: +24 V DC supply voltage
3 GND: ground (0 V)
4 RS 485 Tx+: synchronization
5 RS 485 Tx-: synchronization
14