Leuze electronic CSL 710 Mode D'emploi page 12

EN
Beam spacing
05
10
20
40
Measurement field length
xxx
Equipment
A
Interface
L
Electrical connection
M12
Commissioning
Mounting
NOTICE
Make sure there are no reflecting surfaces in the vicinity.
The light curtains can be fixed with three different methods with the standard ac-
cessories:
– You can mount the light curtain so it is laterally fixed using the T-groove and
sliding block.
– The swivel mount is fixed at the top and bottom of the light curtain and per-
mits 360° turning.
– The optional swiveling mounting bracket is used laterally in the T-groove of
the light curtain and permits +/- 8° turning.
– More information can be found in the chapter "Mounting" of the operating in-
structions.
Pin assignment
See "Electrical connection"
Configuration
You can configure the light curtain directly using the control buttons on the re-
ceiver. The display shows you the individual menu items, which are displayed/hid-
den depending on the configuration.
12
5 mm
10 mm
20 mm
40 mm
Measurement field length [mm], dependent on beam spacing
Plug outlet, axial
IO-Link
M12 connector