Publicité
Les langues disponibles
Les langues disponibles
1800134902 STEAM STATIONS SAFETIES V5.qxp_110x154 15/01/15 14:53 Page6
Environment protection first !
i
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
Problems with your iron?
Problem
Water runs out of the
holes in the soleplate.
Water streaks appear on
the laundry.
White streaks come out
of the holes in the
soleplate.
Brown streaks come out
of the holes in the
soleplate and stain the
laundry.
The soleplate is dirty or
brown and may soil
clothes.
The soleplate is scratched
or damaged.
The red "WATER" light is
on*.
The "anti-calc" light
flashes*.
The steam generator
does not switch on or the
iron indicator light and
the "ON-OFF" light are
not lit up*.
The red "WATER" light is
flashing and the "ON-
OFF" button does not
work*.
* Depending on model
If you have any problems or queries please call our Customer Relations team first for expert help and
advice.
Possible Causes
The water has condensed in the pipes
because you are using steam for the first
time or you have not used it for some
time.
Your ironing board cover is saturated with
water because it is not suitable for use
with a steam generator.
Your water tank has a build-up of scale
because it has not been rinsed out regu-
larly
You are using chemical descaling pro-
ducts or additives in the ironing water.
You are ironing at too high a tempera-
ture.
You have positioned your iron flat on a
metallic iron support or ironed over zips
or metal fasteners.
The water tank is empty.
You have not pressed the "OK" restart
button.
The "AUTO-OFF" system was activated
after 30 minutes of non-use and has
switched off your steam generator.
The appliance has been stored in a cold
place (approximately <10C°).
6
Solutions
Press the steam control button holding
the iron away from your ironing board
until the iron produces steam
Check that your ironing board is suitable
(vented/mesh type ironing board to avoid
condensation).
Rinse the anti-calc collector (see the
"descaling your generator" section or
"rinse the boiler".(depending on model).
Never add any products to the water tank
(see section on "What water to use?" ).
Clean the soleplate as indicated in the
user manual Use a lower temperature.
Always stand the iron upright or on the
iron rest.
Fill the water tank.
Press the "OK" restart button on the
control panel until the light goes out.
Press the "ON-OFF" restart button located
on the control panel.
Unplug the appliance Wait 3 hours for
the appliance to reach room
temperature.
• B
V
H
V
e
G
• D
a
T
S
-
-
-
• D
(F
• D
g
Ih
d
d
B
• D
(o
se
ke
v
Publicité
