Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. Align the bottom hole on the channel to the hole on the shank and insert a 3/4" hex head bolt.
Remember the hole and orientation in these instructions are an example only, yours may be
different.
7. Add hardened washers marked with "F436" on to the large head pin, and then insert into the welded
bushing on the inside top of the channel. Start with 2 hardened washers if trailer frame is 4" or 5". Use
3 hardened washers if the trailer frame is 6", 7" or 8"
2 or 3 Hardened washers and large head pin.
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual. April 06, 2017
See
www.huskytow.com
for Warranty Information/Tech Support. © (2017) DTS. Mfg.
8
Page
Place a 3/4" ID washer onto
the 3/4" hex bolt first.
Publicité
Table des Matières
