Husqvarna 128LX Manuel D'utilisation page 8

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ANSI Z87.1 standard in the USA or EN 166 in EU
countries.
Use gloves when it is necessary, for example when
you attach, examine or clean the cutting equipment.
Use protective boots with steel toe-cap and non-slip
soles.
Use clothing made of a strong fabric. Always use
heavy, long pants and long sleeves. Do not use
loose clothing that can catch on twigs and branches.
Do not use jewelry, short pants or sandals. Do not
go with bare feet. Put your hair up safely above
shoulder level.
Keep first aid equipment near.
Safety devices on the product
For information about where to find the safety devices,
Introduction on page 2 .
see
WARNING: Read the warning instructions
that follow before you use the product.
Do not use a product with defective safety devices.
Do a check of and do maintenance on the safety
devices regularly. If the safety devices are defective,
speak to your Husqvarna service agent.
8
Do not make changes to safety devices. Do not use
the product if protective covers, safety switches or
other protective devices are not attached or are
defective.
For all service and repair work on the product,
especially for the safety devices, special training is
necessary. If the safety devices fail the checks given
in this operator's manual, you must let a service
agent help you. We guarantee that professional
repairs and service is available. If your dealer is not
a service agent, speak to them for information about
the nearest service agent.
Do not use a cutting attachment without an approved
and correctly attached cutting attachment guard. See
Accessories on page 24 .
To do a check of the throttle trigger lockout
1. Make sure that the throttle trigger lockout (A) and
throttle trigger (B) move freely and that the return
spring works correctly.
B
2. Push down the throttle trigger lockout and make sure
that it goes back to its initial position when you
release it.
3. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
A
1570 - 001 - 14.10.2020

Publicité

Table des Matières
loading

Table des Matières