Motostar MP100 Manuel D'installation page 19

Fastening and mounting the box
Fasten the control panel in a protected area; use rounded cross head screws with maximum 6 mm diameter. maximum 6 mm diameter.
Drill through the pre-perforated holes and fi t the cable gland with corrugated pipes for passing through the electric cables.
Pre-perforated hole diameter: 20 mm.

Assemble the pressure hinges.
Fit the hinges into the box (either on the right or left) and fasten them using the supplied screws and washers.
Fit the cover onto the hinges with the permanent snap-in fasteners.
!!
slide the hinges to
rotate them
15 mm~