Motostar MP100 Manuel D'installation page 12

Preliminary works
The following illustrations are mere examples in that the space for fastening the operator and accessories varies depending on
⚠
the installation area. It is up to the fi tter, therefore, to choose the most suitable solution.
The fi gures below refer to a standard installation with gearmotor fi tted on the left and gate opening inward. Installing the

gearmotor on the right is symmetrical.
Warning! For outward opening gate leaves, follow the chapter titled "INSTALLING AND CONNECTING FOR OUTWARD OPENING".
Set up junction boxes fi tted with cable glands and corrugated conduits for the connections coming form the junction pit.
The number of tubes depends on the type of system and the accessories you are going to fi t.

Lay the electrical cables (see the table on types of cables and minimum thicknesses) by running them through the corrugated
conduits and junction boxes.