Publicité
Les langues disponibles
Les langues disponibles
Installing the grille
or griddle.
Grille installation: Go to Step 15.
Griddle installation: The griddle is
factory installed. To complete the
installation, go to Step 16.
15.
Installing the grille:
log burner
A.
Lift the log burner up out of the bay
and set aside.
locating feet
rear spill
guard
drip
tray
B.
Place drip tray on bottom of grille
bay and slide the tray forward so that it is
located side-to-side and against the
locating feet of the rear spill guard.
front spill
insert feet
into slots
C.
Insert the front spill guard feet into
the slots in the rear spill guard as shown.
The rear flange will rest on the burner box.
8
D.
Reinstall the log burner. Make sure
burner's rear flange is seated in slot.
E.
Plug power supply cord into
grounded outlet.
F.
Check the surface burner and grille
flames. Before completing the grille
installation, go to "Check the operation
of the surface burners, grille and griddle"
on Page 9.
G.
Install the wave tray into the
grille/griddle bay. The tab in the left rear
corner of the bay must fit through the slot
in the left rear corner of the wave tray.
guard
H.
Place the wave plate on the wave
tray as shown. The wave plate must be
centered on the wave tray.
I.
Install the grille grate.
slot for
locating tab
locating
wave
tray
16.
Completing the griddle
installation:
griddle
drip tray
A.
Place drip tray in the well at the
front of the griddle. Slide tray forward until
it stops.
B.
Refer to the Use and Care Guide
that came with your Cooktop for
instructions on cleaning and seasoning
the griddle before using.
C.
Plug power supply cord into
tab
grounded outlet.
D.
Check the surface burner and
griddle flames. Go to "Check the
operation of the surface burners, grille
and griddle" on Page 9.
wave
plate
griddle
Publicité
