Belkin OMNICUBE F1DK102P Guide D'installation Rapide page 3

P74243ea_F1DK102P_QIG.qxd 01-04-2003
Introduction
This sheet will guide you through the basic steps needed to
install the 2-Port KVM Switch with Built-In Cabling (the Switch). If you
have any problems during installation, please refer to the User Manual.
You will need the following items to install the Switch:
• 2-Port KVM Switch with Built-In Cabling
• One (each) keyboard, monitor, and mouse
All manuals and user guides at all-guides.com
16:15 Page 2
1
Connecting the Keyboard, Video, and
Mouse to the Console Ports on the Switch
1. Power down all computers.
2. Connect your PS/2-type keyboard and mouse to the KEYBOARD and
MOUSE ports located on the front panel of your Switch.
3. Take the video cable that is attached to your monitor and connect it to
the VGA port on the front panel of the Switch.