Manitowoc RN0408A Mode D'emploi page 18

Bin Thermostat (RN0400 Only)
The bin thermostat sensing bulb is located in the ice
chute and turns the ice machine on and off as the level
of ice in the bin changes.
LESS ICE
IN BIN
RN0400 Bin Thermostat
18
Section 3
Operation
MORE ICE
IN BIN
RN0400 Self-Contained Air or Water-Cooled
Sequence of Operation
NOTE: Ice machines use an auger to remove ice from
the evaporator. Occasional noises (creaks, groans,
squeaks, or pops) are a normal part of the ice making
process.
OPERATION
The ice machine will not start until:
A. The compressor rocker switch is moved to "ON".
B. Ice does not contact the bin thermostat bulb.
C. The water reservoir is full of water.
With power supplied and the compressor rocker switch
in the ON position, the gear motor and refrigeration
system start. The float valve controls the water inlet
valve and water level. The freeze cycle ends when ice
contacts the bin thermostat. A 20 minute delay period
initiates. The ice machine will restart when ice no longer
contacts the bin thermostat and the 20 minute delay
period expires.
Part Number 000007282 4/10