Water Supply And Drain Line Sizing/Connections - Manitowoc RN0408A Mode D'emploi

Installation Instructions

Water Supply and Drain Line Sizing/Connections

! Caution
Plumbing must conform to state and local codes.
Water
Location
Temperature
Ice Making
45°F (7.2°C) Min.
Water Inlet 90°F (32.2°C) Max.
Ice Making
Water Drain
Condenser
90°F (32.2°C) Max.
Water Inlet
Condenser
Water Drain
Bin Drain
Large Capacity
Bin Drain
10
Water Pressure
20 psig (138 kPa) Min.
70 psig (483 kPa) Max.
— —
Standard
20 psig (138 kPa) Min.
150 psig (1034 kPa) Max.
— —
— —
— —
The exact locations of inlets and drains for the model you are working on may vary
SEPERATE BIN AND
ICE MACHINE DRAINS
ARE REQUIRED.
ROUTE DRAIN
TUBING TO OPEN
SITE DRAIN.
Typical Water Supply Drain Installation
Ice Machine Fitting
1/2 in. (1.27 cm) FPTs
3/4 in. (1.90 cm) Pipe Thread
3/8 in. (0.95 cm) Female Pipe Thread
3/8 in. (0.95 cm)
Female Pipe Thread
3/4 in. (1.91 cm)
Female Pipe Thread
1 in. (2.54 cm) Male Pipe Thread
Section 2
Tubing Size Up to Ice
Machine Fitting
1/4 in. (0.64 cm) min
inside diameter
3/4 in. (1.90 cm) min
inside diameter
3/8 in. (0.95 cm) min
inside diameter
3/4 in. (1.91 cm) minimum
inside diameter
1 in. (2.54 cm) min. inside diameter
WATER SHUT-OFF VALVE
REQUIRED ON RN0400 ONLY -
ICE MAKING WATER INLET
TUBING 3/8" MIN. I.D. (.95 CM)
Part Number 000007282 4/10