Publicité
Les langues disponibles
Les langues disponibles
Iveco Daily
1999 - ....
Ref. 1207
Fitting instructions
1)
Remove the footboard en reinstall it one hole higher. Place mounting pieces (-g) and (-h) on the inside
with points (B) fitting the holes where the footboard is attached. Reinsert the bolts, but do not tighten
anything yet.
2)
Place mounting pieces (-e) and (-f) with points (A) and (A') on the provided holes at the bottom of the
chassis and fitting the points (A) of mounting pieces (-g) and (-h). Insert the bolts at points (A-A') and
insert at point (A') the washers in the chassis, but do not tighten anything yet.
3)
Place the tow bar in between the mounting pieces (-e) and (-f) with points (C) and (C') on each other.
Insert the bolts and tighten firmly.
4)
Install the (*) and tighten everything firmly.
Composition
1 tow bar reference 1207
1 flange ball 50T/90
10 bolts M12-35 + nuts
2 bolts M12-35
2 bolts M16-50 + nuts – 10.9
4 washers 40-12-4
12 safety washers 12mm
2 safety washers 16mm
1 security shackle 50T
1 mounting piece (-e)
1 mounting piece (-f)
1 mounting piece (-g)
1 mounting piece (-h)
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
(A-A'-C)
(C')
(*)
(A')
(A-A'-C-C')
(*)
(*)
(C-C')
(C-C')
(A-B)
(A-B)
All bolts and nuts: quality 8.8 / 10.9
Publicité
