Quick Start - NEC MultiSync FP1355 Mode D'emploi

Quick Start

To attach the MultiSync
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB or DVI-A connector of the captive
signal cable to the connector of the display card in your system (Figure A.1).
Tighten all screws.
NOTE: This monitor does not work on DVI digital.
For the Mac: Connect the MultiSync FP
included) to the monitor connector on the Macintosh (Figure B.1). Attach the
15-pin mini D-SUB end of the captive signal cable to the MultiSync FP
Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync FP1355 Macintosh cable adapter, call
NEC-Mitsubishi Electronics Display of America, Inc. at (800) 820-1230.
4. For download information on the Windows
your MultiSync monitor, refer to the References section of this User's Manual.
5. Connect one end of the power cord to the MultiSync FP
other end to the power outlet (Figure C.1).
6. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User's Manual.
FP1355.wpc
® FP ™ monitor to your system, follow
1355
Macintosh cable adapter (not
1355
®
USB Cable Detachable
Signal Cable
DVI-A
Figure A.1
3
5
95/98/2000/Me INF file for
monitor and the
1355
15-pin mini D-SUB
1/19/01, 1:20 PM
1355