Publicité
7 Unscrew the lock ring that holds the narrow end plate.
Narrow
end plate
Lock ring
8 Remove the narrow end plate.
Make sure to apply a uniform force when pulling the plate along the axis.
9 Pull the tyre out of the wheel and install the new one.
10 Re-install the narrow-end plate by pushing it in place while applying an axial force.
11 Re-install the lock ring to lock the narrow-end plate.
IMPORTANT: Do not overtighten the lock ring.
12 Re-install the assembled wheel back in place and screw both chassis brackets.
Do not tighten them yet.
NOTE: Both chassis brackets have an alignment mark to help align the phased array
probe.
13 Turn the wheel so that the phased array probe is perpendicular to the flat surface
and tighten the chassis bracket screws.
14 Re-install the indexing arm bracket, the protector of the phased array cable, and
the front roller if required.
15 Fill the wheel as indicated in section 4.1 "Filling the WheelProbe 2 with Water".
SOFRANEL
- 59 rue Parmentier 78500 SARTROUVILLE - tel 01 39 13 82 36 - fax 01 39 13 19 42
Alignment marks
Wide end
plate
www.sofranel.com
-
Publicité
