Publicité
6 Select the WheelProbe 2 Remote Sync parameter and select Clear all remotes.
7 On the test instrument keypad, press the OK button.
Once the bar graph indicating the progress disappears, press the Cancel button or
select Add remote to pair a new remote control with the WheelProbe 2.
7.5 Replacing the Tyre
Whenever the tyre has a tear or a crack, or shows wear, the wheel tyre must be
replaced.
To replace the tyre:
1 Disconnect the WheelProbe 2 from the test instrument.
2 If the front roller is installed, unscrew the two thumbscrews holding the front roller
bracket and remove it.
3 Unscrew the purge screw and empty the water from the wheel.
4 Using a 2.5-mm Allen key, remove the two screws that secure the cable protector
of the phased array cable.
5 Using a 2.5-mm Allen key, remove the indexing arm bracket.
6 Remove both chassis brackets that hold the wheel shaft on both side of the
WheelProbe 2.
IMPORTANT: Make sure that you do not damage the phased array cable while
pulling the wheel out of the WheelProbe 2 assembly.
SOFRANEL
www.sofranel.com
- 59 rue Parmentier 78500 SARTROUVILLE - tel 01 39 13 82 36 - fax 01 39 13 19 42
-
Publicité
