Franke OPERA Manuel D'installation Et Mode D'emploi page 10

EN
For United Kingdom, Northern Ireland
and Republic of Ireland.
Electrical connection
The FRANKE cooking hob comes with a 3-core
power cable with free terminals.
X X
Ensure the following:
– The characteristics of your household
electrical power supply (voltage, maximum
output and current) are compatible with
those of your FRANKE hob.
– The plug and the socket can be easily
reached and are positioned so that no
live part is accessible when inserting or
removing the plug.
– A 3 x 0.75 mm2 H05RR-F type cable
for completely gas hobs is used when
replacing the power cable.
– The terminals of two appliances are not
connected to the same plug.
– The polarities of the free terminals
(Blue = Neutral = (1) /Yellow and Green =
Earth =(2) / Brown = Live = (3)) are respected.
1
2
3
L
POC 6 3GAV-D-O / POI 6 3GAV-D-O / POL 6 3GAV-D-O / POT 6 3GAV-D-O POC 6 3GAV-D-O / POI 6 3GAV-D-O / POL 6 3GAV-D-O / POT 6 3GAV-D-O
1
1
3
1
2
3
N
Adjustment to different types of gas
WARNING: This operation must be performed
2
by a qualified technician.
Minimum flame adjustment
X X
Remove the knob.
X X
Adjust the minimum flame by turning the
adjustment screw clockwise to decrease
the flame and anticlockwise to increase it.
The screwdriver for adjustment is supplied
with the accessories.
Replacing injectors
Not supplied injectors must be requested
to the customer service.
IMPORTANT: All the appliances are factory-set
for natural gas (G20). If a different type of gas
is to be used, change the injectors as follows:
– Remove the grids, burner caps and
flame-spreaders;
– Unscrew the injectors and replace them
with those provided and suitable for the
gas supply, making sure the marking
matches that given in the table;
– Refit the flame-spreaders, burner caps
and grids.
These burners do not require air adjustment.
– 10 –
-
+
ø
7