Safety Precautions; Initial Operation - WMF Kult Pro Mode D'emploi

Masquer les pouces Voir aussi pour Kult Pro:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11

Safety precautions

▪ Only connect the appliance to earthed wall sockets that have been installed in accordance with the
regulations. The power cord and plug must be dry.
▪ Do not pull or clamp the connection cable over sharp edges. Do not leave it dangling. Protect it
from heat and oil.
▪ Do not place the appliance on hot surfaces, such as on hotplates or similar areas, and do not
operate near naked fl ames.
▪ Never pull the mains plug out of the socket by the cable or with wet hands.
▪ Do not switch on the appliance when the mixing container is empty.
▪ Ensure that the blade unit is attached fi rmly and the lid is fastened correctly to the mixing
container before using the appliance. Always operate the appliance with the lid closed.
Always wait for the blades to come to a standstill before removing the lid and/or the mixing
container.
Always check that the lid is also connected at the angled pouring corner.
▪ The appliance must not be operated unsupervised.
▪ Never place objects into the mixing container whilst the appliance is running.
▪ Do not reach into the mixing container before unplugging the appliance from the mains.
▪ Always turn the on/off switch to the "off" position ("0") before removing the mixing container.
▪ Do not fi ll the mixing container to beyond the MAX mark (hot foods should not be added beyond
halfway to the MAX mark).
▪ Do not exceed the volumes and processing times listed in the relevant table.
▪ Never run the appliance for more than 7 minutes without interruption. Allow the appliance to cool
down at room temperature before continuing.
▪ Caution! There is a risk of scalding when processing hot food. In extreme cases, the mixing
container could become damaged. Only food with a maximum temperature of 60°C may be
processed. When processing hot food or ingredients that could foam, do not fi ll the mixing
container more than halfway to the top and hold the lid down fi rmly on the jug with your hand
during operation.
▪ Care should be taken when handling the sharp cutting blades, emptying the jug and during
cleaning.
▪ The appliance must be switched off and disconnected from the mains before accessories or
additional parts that move during operation are replaced.
▪ Stop using the appliance and/or pull the mains plug out of the socket immediately if:
The appliance or power cord is damaged
You suspect that the appliance may be defective following a fall or similar incident.
In such cases, arrange for the appliance to be repaired.
▪ The blender may not be connected to an external switch, e.g. a timer or a circuit that
regularly switches on and off.
▪ Pull out the mains plug:
if malfunctions occur during use
Before cleaning and care
After use
▪ Do not immerse the drive unit in water.
▪ No liability is accepted for any damage resulting from misuse, incorrect operation or improper
repair. Warranty payments are also excluded in such cases.
▪ The appliance is not intended for commercial use.
14
Use
The appliance is suitable for mixing and chopping foods such as fruit, vegetables and nuts as well as
for preparing juices, smoothies, shakes and soups.
The blender has six automatic programmes:
Smoothie
The Smoothie programme can be used to easily prepare smoothies. The appliance works alternately at
different speed levels.
Soup
The speed of the blades heats and blends cooked vegetables and stocks.
Chopping
For simple chopping of hard foods such as nuts. The blender works alternately at different speed levels
Ice Crush
The Ice Crush button can be used for crushing ice cubes easily. Fill with a maximum of 12 ice cubes
(approx. 20 x 25 mm). The blender works in pulse mode.
Sorbet
To prepare the sorbet, the appliance works constantly at one speed level.
Cleaning
Simple cleaning of mixing container and blade unit.
In addition to using the programmes, the appliance can also be operated in pulse mode using the pulse
button and the speed can be set at 10 variable levels (1-H).

Initial operation

Clean the mixing container, lid and closing cap prior to fi rst use. Take care not to injure yourself on
the sharp blade. Place the mixing container on the drive unit. The handle must be facing to the right
or left. Add your ingredients. Note the maximum fi lling level on the mixing container. Filling past this
amount may lead to overfl owing, depending on the consistency of the ingredients. For foods that
froth, do not fi ll the jug more than half full. Close the mixing container using the lid and closing cap.
Warning: The blender will only switch on if the mixing container and lid have been fi tted correctly.
2
To this end, place the spout of the lid sideways against the pouring
1
spout on the mixing container and gently press the lid onto the
mixing container (1).
Then press the locking mechanism on the lid downwards until it
clicks into place in the handle (2). A safety shutdown prevents
operation without the jug and lid.
Switch on the appliance using the on/off switch, the function
buttons are illuminated and the speed level 5 is shown in the display as the default speed.
Note: If no mixing container with lid is on the drive unit when the appliance is switched on, an
acoustic signal is emitted and the display is not illuminated. After placing the mixing container with
lid onto the drive unit, the start/stop button is illuminated and the appliance is in standby mode. The
appliance is ready to use when the start/stop button is pressed again.
Select your programme or use the manual speed setting by pressing the +/-. To start, press the start/
15

Publicité

Table des Matières
loading

Table des Matières