Télécharger Imprimer la page

Batavia BT-FL001 Traduction De La Notice Originale page 15

Échelle

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
Do NOT try to move the ladder while standing on the ladder.
Never use the ladder on stairs that are not level. Otherwise the ladder can
tip over or you could lose your balance.
Only use the ladder when fully assembled, and only in those positions
that are described in this user manual.
If using the ladder as a straight ladder, do not climb higher than the third
last rung. If using the ladder as a stepladder, do not climb higher than the
second last rung.
Always wear sturdy footwear with a non-slip sole when using the ladder.
Only wear close-fitting clothing that cannot get caught on the ladder.
Always keep the ladder dry, clean and free of rubble and foreign bodies.
Clean the ladder after each use.
It is always recommended to have the ladder held firm by another person.
This increases the stability of the ladder.
Always ensure that the ladder is protected against damage (e.g. unse-
cured work materials) when transporting in a vehicle. When transporting
the ladder on a roof rack or in a truck, the ladder must always be suitably
secured (tied down). Always ensure there is adequate load safety.
The 3-in-1 multi-function ladder must be put up in the correct position,
e.g. the correct angle for straight ladders (inclination angle approx. 1:4),
for stepladders, they must be completely open with rungs or treads
horizontal.
The 3-in-1 multi-function ladder must never be repositioned from above.
When positioning the 3-in-1 multi-function ladder, pay attention to the risk
of collision, e.g. with pedestrians, vehicles or doors.
Do not lean too far out from the 3-in-1 multi-function ladder. Users should
keep their belt buckle (the navel) between the stringers and stand with
both feet on the same step/rung.
Set up
All base crossbeams must be attached before use.
Remove the transport locks at both ends of the ladder.
Mount the base crossbeams to the respective end of the ladder stringers
at the end of the ladder and secure these with the assembly material
included in the delivery contents.
Do NOT use the ladder without the mounted base crossbeams, except
when this is expressly prescribed.
Always check that the base crossbeams are securely attached before
placing weight on the ladder.
Only use the base crossbeams supplied.
7062441 Ma-14Tlg-1512-08.indb 15
English
15
09-12-15 10:06

Publicité

loading

Ce manuel est également adapté pour:

7062441