Publicité
Les langues disponibles
Les langues disponibles
6.0 Maintenance
6.1 Maintenance and Cleaning
► Before any work on the machine itself, pull the
mains plug.
► For safe and proper working, always keep the ma-
chine and ventilation slots clean.
The machine must then be sent to an after-sales Ser-
vice agent. Addresses are listed in the Section "After-
sales service and customer assistance".
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
WOLFF power tools.
In all correspondence and spare parts orders, please
always include the machine number specifi ed on the
type plate of the machine
6.2 Spare parts
Spare parts can be found on the internet at:
http://webcatalog.wolff -tools.com
7.0 Trouble shooting
Fault
Possible cause
The machine
Power interrupted
does not start
Fuse defective
Cable defective
Plug defective
The machine
Guide rod incor-
does not start
rectly mounted
The safety switch
Switch-on le-
allows the lever
ver (3) cannot
(3) to be operated
be operated
only when the
handle is inclined.
8.0 Disposal information
Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
must be collected separately and disposed of in an envi-
ronmentally correct manner.
Subject to change without notice
Remedy
Contact Electrici-
an for repair and
/or replace parts
Install guide rod
correctly
Tilt the handle of
the machine.
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable
EN
23
Publicité
