Publicité
Les langues disponibles
Les langues disponibles
V1.0
2.
Place the work guard across the sanding belt. Bolt the plate to the belt side of
the sander. It is properly installed when there is a space between the belt and
the work guard.
MOUNT TOOL ON A WOOD WORKBENCH
The hardware to mount the tool is not included.
1.
Clean the work area where the tool will be mounted.
2.
Position the tool, check that it will be level and there are no obstructions around
it that will interfere with a long workpiece.
3.
Mark the workbench through the holes in the base of the tool.
4.
Move the tool aside and drill holes through the workbench equal to the
diameter of the bolts.
5.
Align the tool's bolt holes with the holes drilled in the workbench.
6.
Drop a bolt through the bolt holes. Ensure the bolt is long enough to
protrude from the bottom of the workbench.
7.
Slide a flat washer over the bolt and secure the tool in place with a nut.
Repeat with each bolt. Tighten all bolts.
SAWDUST PORT
The sawdust port directs the accumulated sawdust from the tool. Connect a
dust collection system to the 2-1/4 in. sawdust port. Attach a bag that is not
airtight to the port if a dust collection system isn't available. Continue to wear a
dust mask as sawdust may still be suspended in the air.
OPERATION
SAFETY LOCK SWITCH
Remove the yellow tab of the ON/OFF switch to prevent the tool from being
switched on. Reinsert to yellow tab and push to click into place. The ON/OFF
switch is functional again.
Visit www.princessauto.com for more information
6 in 1/2HP Belt Sander
9009689
11
Publicité
