Publicité
Les langues disponibles
Les langues disponibles
V1.0
IDENTIFICATION KEY
A
Work Guard
B
Belt Tension Lever
C
Sanding Disc
D
Mitre Gauge
E
Work Table
F
Sanding Belt
G
Tracking Control Knob
H
Base
I
ON/OFF Switch
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List. Letter
references in parenthesis (A) refer to the included Identification Key. Dashed
numbers in parenthesis (Fig. 1-1) refer to a specific point in an illustration
or image.
1.
The work table may be installed to use with the sanding disc or the sanding
belt. The work guard must be removed if installing on the sanding belt.
a.
Disc - Position the work table against the disc guard with the support
bracket on the face with the dust collector connection. Align the
support bracket's pin with the top bolt hole.
Slide a flat washer over the lock knob and insert through the curved
opening and into the threaded bolt hole below the first. Screw the lock
knob in until the work table is secure.
b.
Belt – Position the work table perpendicular to sander's top. Insert the
support bracket's pin into the bolt hole on the belt side of the sander.
Slide a flat washer over the lock knob and insert through the curved
opening and into the threaded bolt hole parallel to the pin's bolt hole.
Screw the lock knob in until the work table is secure.
Please read and understand all instructions before use. Retain this manual for future
reference.
9009689
Publicité
