Hauff-Technik MIS40 Instructions D'installation page 18

MIS40
Then guide the media lines through the hole in the
seal insert from the outside of the building (see fi g.:
23).
For easier entry and stabilisation of the media
lines, it is possible to insert an M4 x 70 allen key
in the end of the media lines, for example.
7 Installing the tubular guide elbow
(accessory)
The tubular guide elbow can be used only for media
lines up to Ø 16 mm. (Article number of tubular
guide elbow MIS 60-RB including adapter (packing
unit contains 10): 3030300108).
Insert adapter for tubular guide elbow on the inside
1
of the building into the wall entry pipe over the
media lines so that it is fl ush with the wall (see fi g.:
24).
Then push the tubular guide elbow over the media
2
lines into the adapter as far as it will go (see fi g.:
25).
The minimum bending radiuses of the media
lines must be observed!
Turn the tubular guide elbow to face in the desired
3
direction and then bend it until the whole of the
guide elbow has snapped into position (see fi g.:
26).
Service telephone +49 7322 1333-0
18
Subject to alterations.
Art. Nr.: 3030335112 Rev.: 00/2020-04-28
EN