Technical Data - Faber e-MatriX heat 800/500 I Manuel D'installation

Installation manual e-MatriX heat 800/500 I,II,III and e-MatriX heat 800/650 I,II,III
10. Clean the nozzle with a soft brush and
flush out thoroughly with water.
Reverse the steps above to reassemble.
Cleaning air filter
1. Gently slide the air filter upwards out of
its plastic holder, see fig. 8.0.
2. Gently rinse with water in the sink and dry
with fabric towel before returning.
3. Replace the air filter.
4. Place the fuel bed, see chapter 6.
5. Place the front glass, see section 5.
Replacing transducers
 Please note!
Press the mains switch of the Control box to
the "OFF" (0) position, see fig. 4.0-D and
disconnect the power supply.
1. Follow the first 7 steps in section
"Cleaning water sump" in chapter 9.1 to
gain access and remove the transducers.
2. Place the new transducers and repeat the
steps above in reverse order.
(Please take note that the transducer
cables will not block the opening of the
cones).
Cleaning mesh filter

10 Technical data

Full Heat
Half Heat
Flame Only
Standby
Batteries Remote
Water Consumption
Inlet Water Pressure
Water Connection
28 < < < <
Replacing in-line filter
When the absorption valve (fig. 5.0-K) is activated,
the sponge need to be replaced. The absorption
valve is located on the right front at the bottom of
the Engine.
230 V 240 V
2050 W 2250 W
1150 W 1350 W
245 W 260 W
5 W 5 W
(2x) 1,5 AA V
0,15 L/h
0,5-8 Bar
½ or ¾ Inch
1. Turn off the water supply.
2. Close the ball valves.
3. Unscrew the base and clean the filter
inside.
1. Turn off the water supply.
2. Close the ball valves.
3. Replace the filter. Note the flow direction
mark on the filter!
9.2 Resetting absorption valve (fig. 5.0-K)
1. Take out the sponge.
2. Fix the cause of the water leakage and
remove any water at the bottom of the
engine.
3. Place the new sponge and open the
absorption valve by pressing down the
white clamp.