Installation manual e-MatriX 1050-1300/400 I, II, III Linear
Dear user
Congratulations on your purchase of a Faber fire! A
quality product from which you will experience
warmth and atmosphere for many years. We rec-
ommend that you read this manual carefully be-
fore using the fireplace. If any problem arises de-
spite our strict quality control, you can always con-
tact your dealer or Glen Dimplex Benelux B.V.
For any warranty claims, it is essential you first
register your fireplace. During this registration,
you'll find all information regarding our warranty.
➢
Please note!
The details of your fireplace can be found in
the user manual.
You can register your fire
at:www.faberfires.com
Glen Dimplex Benelux B.V.
Address: Saturnus 8
NL-8448 CC
Heerenveen
Tel:
+31 (0)513 656 500
Email:
contact@faberfires.com
Info:
www.faberfires.com
1.1
Introduction
Only have the fire installed by a qualified installer
according to the water and electric safety
Regulations. Read this installation manual properly.
Where the installation instructions are not clear,
national/local regulations must be followed.
1.2
Check
•
Check the fire for transport damage and
report any damage immediately to your
supplier.
•
Check whether all of the parts below are
included:
Control box
o
Remote (incl. batteries)
o
Ash material
o
Suction cups (2x)
o
Remote access door
o
Spare transducers (2x) and
o
sponge
1.3
CE declaration
We hereby declare that Glen Dimplex Benelux B.V.
released Faber heating appliance by its design and
construction method complies with the European
Safety Standards EN60335-2-30 and the European
Standard Electromagnetic Compatibility (EMC)
EN55014, EN60555-2 and EN60555-3 these cover
38 <
<
<
<
the essential requirements of EEC Directives
2014/35/EU and 2014/30/EU.
Product: electric fire Opti-myst
Model: e-MatriX Linear 1050/400 I,II,III
e-MatriX Linear 1300/400 I,II,III
This declaration will become null and void as soon
as the unit is in any way modified without written
authorization of Glen Dimplex Benelux B.V.
Safety instructions
•
Do not use outdoors.
•
Do not use in the immediate surroundings
of a bath, shower or swimming pool.
•
The fire must be installed according this
manual.
Installation requirements
3.1
Water supply
•
Install a water connection with an ½" or
¾" external thread connection, placed at
an accessible location.
•
Install an EA backflow protection valve,
this is not included with the appliance.
•
Water pressure on the appliance between
0,5 and 8 Bar. Where required, use a pres-
sure reducing valve.
3.2
Power supply
Electric connection -230VAC/50Hz earthed and
placed at an accessible location.
Preparation and installation instruc-
tions
4.1
Preparing the fire
•
Make sure that all packaging materials
have been removed.
•
Remove the packaged parts.
•
Remove the front glass, see chapter 5.
4.2
Placing the fire
➢
Please note!
•
Always the fire must be fitted with the
back to a wall.
•
The fitting of a chimney breast is manda-
tory.
•
For a proper functioning of the fire, al-
ways ensure that the fire is levelled.
Floor standing
Place the fire in the correct position and fix it to
the wall, see fig. 1.1.