Mosquito Magnet Liberty Plus Manuel De L'utilisateur page 7

Instructions
**READ MANUAL BEFORE STARTING**
Starting Instructions
It is recommended that you read the entire manual
before starting the Liberty Plus trap.
1. Charge your Mosquito Magnet ® Liberty Plus for
24 hours at the beginning of each season.
2. Connect regulator to propane tank (see page 8).
3. Slowly open propane tank valve.
4. Push ON/OFF switch to ON position. LED light will turn
solid orange indicating warm-up. After 15 to 25 min.
trap LED light will turn solid green indicating the trap
is running at full capacity.
When Not In Use
If the unit is not in use, the gas must be turned off at the
supply cylinder. Storage of this unit indoors is permissible
only if the cylinder is disconnected and removed.
Cylinders must be stored outdoors, out of reach of
children and must not be stored in a building, garage
or any other enclosed area.
End of Season Storage
Push ON/OFF switch to OFF position to shut down the
Liberty Plus. The LED light will go out and the fan will
continue running until trap is cool. Close the propane tank
valve and disconnect regulator. Also, disconnect the
battery, but make sure not to remove battery from the trap.
Any open Mosquito Magnet attractant should be
®
removed and discarded. See attractant label for
disposal instructions. The bug bag should also be
discarded prior to storing the Liberty Plus.
STORAGE: Liberty Plus should be stored indoors in a
garage or shed in the off-season. Cover trumpet to
prohibit insects from nesting. Cover unit with trap cover
available at www.mosquitomagnet.com or with a tarp
and secure tightly at the bottom to keep out dust, spider
webs and other debris.
NOTE: It is recommended that you use the Quick Clear
cartridge before seasonal storage to avoid build-up
of contaminants during off-season (see page 13).
Please visit www.mosquitomagnet.com to find
a local service provider for your spring tune-up.
11
ON/OFF Switch
For Best Results (unit must run for 24 hours/day)
• Your trap will begin capturing immediately with
significant reduction in the mosquito population in
7-10 days. Allow 4 – 6 weeks to significantly reduce the
mosquito population in your yard.
• Never spray insecticide in or around trap.
• Trap can be left running in the rain, but do not place trap
directly above a water source (sprinklers, hose, etc.).
• If using lime or fertilizer compounds, be sure to shut down
the Liberty Plus first to prevent dust or fine mist from being
drawn into trap and clogging bug bag.
Warning: Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. Read the
installation, operating and maintenance instructions
thoroughly before installing or servicing this equipment.
Caution: The gas pressure regulator provided with this appliance
must be used. This regulator is set for an outlet pressure 11.0 in.
water column.
The gas supply must be turned off at the LP-Gas supply cylinder
when this appliance is not in use.
Shut Down
Maintenance
Maintenance
• 21 Day Maintenance Cycle
- Refill propane. (Propane lasts approximately 21 days with
24-hour/7-days operation.)
- Replace short-range attractant cartridge. See Mosquito
Magnet ® attractant label for instructions.
- Empty or replace bug bag.
• Utilize the Quick Clear adapter at first tank change and every
second tank change thereafter.
• Periodically wipe down the outside of the Liberty Plus with
a clean, water damp cloth.
• Charge your Mosquito Magnet Liberty Plus for 24 hours
at the beginning of each season.
Note: Bug bags should be replaced when half full. You can find all your accessory needs
Maintenance Schedule Possible Cause
at www.mosquitomagnet.com or at your local Mosquito Magnet Dealer or Service Center.
Example
Purchase Date 4/1
Warranty Submission 4/1
Start Up Date 4/1
Propane & Attractant Change 4/21
Quick Clear Cartridge 4/21
Propane & Attractant Change 5/11
Quick Clear Cartridge —
Propane & Attractant Change
5/31
Quick Clear Cartridge
5/31
Propane & Attractant Change
6/20
Quick Clear Cartridge
—
Propane & Attractant Change 7/10
Quick Clear Cartridge 7/10
Propane & Attractant Change 7/30
Quick Clear Cartridge —
Propane & Attractant Change
8/19
Quick Clear Cartridge
8/19
Propane & Attractant Change 9/8
Quick Clear Cartridge
—
Propane & Attractant Change 9/28
Quick Clear Cartridge 9/28
Propane Tank Changing Tips
When attaching the regulator knob to a tank after a tank change,
be sure to fully tighten the regulator knob onto the tank. No need
to use tools, but do turn the knob as far as possible by hand.
When this is done, loosen the knob 1/4 turn, then re-tighten
to maximize seal.
The purpose for this is to fully engage the regulator onto the tank. If
the regulator is not fully engaged, the flow of gas may be restricted
to the point where the trap will show a gas empty code. If this
occurs, press the off button, close the tank valve, and remove the
regulator from the tank. Re-attach the regulator and try again.
Season 1 Season 2 Season 3 Season 4
12