GiBiDi SR2 Instructions Pour L'installation page 14

14
UK
STORING A REMOTE CONTROL WITH 1 BUTTON:
• You have to follow the same procedure, but push two times the same button, matching it to opening and closing
function.
ROLLING CODE FUNCTION:
If you use "Rolling Code" transmitters, as soon as you store the first transmitter, the control unit can be matched only
to transmitters of the same type (for instance, ESBI transmitter).
If the first transmitter stored is without "rolling code", the control unit can be matched to any type of transmitters with or
without rolling code.
STORAGE BY AIR:
It is possible to match a transmitter long distance without interacting directly with the control unit (by SEL button).
To do this, it is sufficient to push the button of any transmitter previously stored (the control unit starts the motion),
hold down any button and wait 10s; the control unit stops the motion and, after about 10s, you hear an acoustic signal
indicating that the control unit is in programming phase.
Then push the buttons of the transmitter you want to store (same procedure of the previous paragraph).
TRANSMITTERS CANCELLATION:
If you want to cancel all the transmitters stored, push the SET button for 10s, as F1 CODE LED is blinking.
You will hear a long acoustic signal and F1 CODE LED switchs off, indicating the cancellation of the memory.
It is possible to store up to 75 transmitters. If all the transmitters have been stored, repeating the
programming operation, the control unit will beep 10 times, signalling that more storage are not
possible.
F2 WORKING TIME PROGRAMMING
The control unit has a default 30s working time.
If you want a different time, program it (when the rolling shutter is closed) as described below:
• Push the SEL button for 1s (to enter in configuration mode) and press SEL button until F2 MOTOR T. LED blinks.
• As the LED blinks, hold down SET button: the rolling shutter starts rising and, when it reaches the desired point,
release SET button. The F2 MOTOR T. LED is on and the acoustic signal indicates that the operation is successful.
• We suggest to store a little longer time, after the rolling shutter reaches the limit switch.
• If you want an endless working time (you have to disable the function), position with SEL button on blinking
F2 MOTOR T. LED. Push SET button for less than 1s, as the LED is blinking.
The LED is off, because there is not any working time.
(MOTOR T. function - 4 min. max)
SR2