Publicité
Les langues disponibles
Les langues disponibles
SR2
CONTROL UNIT PROGRAMMING
Using SEL and SET buttons of the control unit, it is possible to enable, disable and program some functions and
parameters, as indicated in the table below.
SEL button :
Push the button for 1s to enter the configuration menu and, pushing it many times, 7 LEDs will turn on in sequence:
each LED programs a specific function.
The blinking LED indicates the function that you can enable and / or modify (see the table), using SET button.
The selection keeps active for 10s, after that the control unit comes to the default status, if any change has been
made.
SET button:
allows the programming and / or enabling of the information or time depending on the type of function chosen
by SEL button.
LED
F1
F2
F3
F4
F5
F6
F7
F8
During the programming, the control unit does not reply to the commands by remote control or low
tension keyboard.
F1
REMOTE CONTROLS PROGRAMMING
It is possible to make the control unit work by remote controls with 1 or 2 buttons.
The programming of the transmission codes of the remote control is the following:
STORING A REMOTE CONTROL WITH 2 BUTTONS:
• Push the button SEL for 1s, F1 CODE LED starts blinking slowly.
• Push the button of the transmitter you want to store as OPENING button, an acoustic signal indicates that the
storage has been completed and F1 CODE LED starts blinking fast.
• Push the button of the transmitter you want to store as CLOSING button, an acoustic signal indicates the storage of
the second button has been completed. F1 CODE LED remains on, indicating there is a code in the memory.
Now it is possible to start the learning procedure for another transmitter.
FUNCTION
CODE
MOTOR T.
PAUSE T.
MAN / CL.
MAN / OP.
BEEP
FL. / COUR.
Flashing and courtesy light management
LS
DESCRIPTION
Remote controls storing
Motor time
Reclosing time
Dead man in closing
Dead man in opening
BUZZER enabling
Limit switch management
(CODE function)
13
UK
Publicité
