LGB 26253 Mode D'emploi page 7

SERVICE
Lubrication
The axle bearings and the side rod ends should be lubrica-
ted occasionally with a small amount of LGB Maintenance
Oil (50019).
Replacing the light bulbs
Front/rear lights: Pull the lantern housing away from the
model. Remove and replace the bulb. Reassemble.
Cab light: Using tweezers, remove and replace the bulb.
Replacing the traction tire
The gearbox must be removed to replace the traction tire:
- Remove the hex screws on both rear drive wheels.
- Remove the side rods from the wheels.
- Underneath the gearbox, you find six screws. Remove the
first and sixth screw.
- Carefully pull the gearbox out of thechassis.
- If necessary, unplug the wiring cable.
- Use a small, straight-blade screwdriver to replace the trac-
tion tire: Pry the old traction tire out of the wheel groove.
- Gently insert the new traction tire into the wheel groove.
- Make sure that the traction tire is seated properly in the
wheel groove.
- Reassemble.
Replacing the smoke generator
- Pull the safety cover out of the smoke stack (Fig. 4).
- Use pliers or tweezers to pull the old smoke generator out
of the stack (Fig. 5).
- Cut the wires to the old generator and attach them to the
replacement generator (Fig. 6).
- Insulate the connections and push the replacement
generator into the stack.
- Reassemble.
7