Undercounter Dishwasher With Built- In Water Softener - Adler DWA2050 Guide Rapide

3E – UNDERCOUNTER DISHWASHER
WITH BUILT- IN WATER SOFTENER
These models have continuous softener in the
dishwasher water circuit. By means of special
resins, this device removes the calcareous
substance from the feed water, supplying
decalcified water for washing.
Automatic watersoftener works properly if the
resins are regenerated
frequency depending on the hardness of the
water and the number of wash cycles carries out.
3E1 – SALT CONTAINER / FILLING
The water can be only softened if there is salt in
its container. The salt container must be filled
when the dishwasher is used for the first time
and before starting a new cycle.
3E2 – MECHANICAL VERSIONS
It is necessary to fill the salt container every 5
watersoftener regenerations.
3E3 – ELECTRONIC VERSIONS
If available, fill the salt container everytime the
message "Add SALt" is displayed or during
flashing button "H".
Add
SALt
N.B. (Mechanical / Electronic Versions)
It is not possible to start a new watersoftener
regeneration if salt container is empty.
Watersoftener regeneration process must be
made only after draining out completely the
water inside the tank. Salt container has
always water on its inside; however it is
normal if some water comes out of salt
container while filling it.
3E4 – ALL MODELS
1- Turn OFF the machine by pressing button "A"
On/Off.
2- Unscrew the cap of salt container located
inside the tank by turning it anticlockwise.
(Fig.44)
Fig.44
3- Pour approx. 1 kg of coarse salt [NaCI] in the
container. (Fig.45)
Fig.45
periodically, with
ADD SALT
4- Screw the cap of salt container by turning
it clockwise.
WARNING!
ONLY SALT MUST BE PLACED INSIDE THE
SALT CONTAINER. DO NOT INTODUCE ANY
OTHER CHEMICAL SUBSTANCES SUCH AS
DETERGENT, RINSE AIS OR DESCALING
AGENT, SINCE THESE WOULD INEVITABLY
DAMAGE THE APPLIANCE. SUCH DAMAGE
INVALIDATES ANY WARRANTY
RELIEVES THE MANUFACTURER OF ALL
LIABILITY
.
3E5 – RESINS CHART RANGE
Water Hardness 20°F
(french degrees)
Water Liters 240
Treatment
Cycles Number 120
3E6 – WATERSOFTENER REGENERATION
It is important to follow the Resins Chart
Range in order to have correct regeneration
with the watersoftener.
1- Ensure that salt container is full.
2- Turn OFF the machine by pressing
button "A" On/Off.
3- Open the door and remove the water
flow device. (Fig.46)
Fig.46
4- Drain out completely the water from the
tank. For models with Drain Pump see
par. 3D.
5- Hold button "H" regeneration for few
seconds until it starts regeneration
process. (Fig.47)
H
Fig.47
- The machine automatically complete the
regeneration process in approx. 18 min.
AND
30°F 40°F
150 120
75 60
20